Carbon Block - Length 40 Micron Rating 5 Gasket EPDM
Carbon Block - Length 40 Micron Rating 5 Gasket EPDM
Carbon Block - Length 40 Micron Rating 5 Gasket EPDM
Carbon Block - Length 40 Micron Rating 5 Gasket EPDM
On Sale Sold out

Carbon Block

Length: 40 Micron Rating: 5

Our 5 micron, 40 inch length carbon cartridges produced by extrusion process, provide long service life and superior adsorption performance compared to conventional granular activated carbon cartridges together with minimum fines.

With high mechanical strength and low ash content, the carbon block structure prevents channelling, bypassing, fluidising or unloading of carbon fines. To prevent premature plugging of the activated carbon layer the filters incorporate an effective pre-filtration layer designed to intercept gels and large particles.

Our activated carbon filter cartridges use premium grade coconut shell extruded carbon blocks and can be supplied in a range of lengths and end cap configurations to meet the requirements of your process application.

Applications:

  • PCB solutions
  • Plating and coating solutions
  • Industrial water treatment
  • Drinking water treatment
  • Chlorine and VOC removal
  • Tastes, odours and organic pigments reduction
  • Chlorinated compounds reduction
  • Oils and aromatic compounds removal

Box Quantity: 6

Please take care to select the appropriate end caps before ordering. Terms and conditions apply.
£259.00 ex VAT
£259.00 ex VAT
This product is currently sold out.

Maximum Dimensions: 70mm OD x 27mm ID x 1016mm 1520g

Micron Rating (Nominal): 5
Initial Δp (psi) @ flow rate lpm: 1.5psi @ 20 lpm

Chlorine Reduction @ flow rate lpm: >92,000 litres @ 20 lpm

Box Quantity: 6

APPLICABLE TO ALL CARBON BLOCKS
Warning: For drinking water applications, do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Note: The UKX cartridge will contain a very small amount of carbon fines (very fine black powder) and a new cartridge after installation should be flushed with sufficient water to remove traces of the fines from your water system before using the water. It is recommended that you run (flush) for at least 20 seconds prior to using water.

Note: Estimated capacity tested at given flow rate using 2 ppm free available chlorine at continuous flow to withgreater than 90% reduction.

Note: Increased flow rates may result in less effective chlorine reduction.

Note: Micron ratings are based on 85% removal of given particle size.